Go to homepage
Wishlist
0
Shopping cart

Product info "Walther GSP from 1976 until 2022, also Expert"

Standard grip, according ISSF rules, stippled and oiled, for Walther GSP from 1976 until 2022, also Expert. 
With adjustable palm rest, moveable 5mm up and down from the middle position! 

For GSP without safety and a lower frame thickness of 16mm. The grip will be fixed with one screw from below. For it you need the original fixing part (see photos and below). The fixing part of the Nill Company will NOT FITT! 
Here you will find all GSP versions built before 2022!
Skip image gallery

€224.13

Delivery time 12 weeks (made to order) plus transport time

Grip parameters
The necessary information for your grip are requested here:
If you are unsure about this, you can upload a outline sketch of your hand in the last step!
(required)
Width of the hand measured across the finger base joints.
If you are between two sizes, choose the larger one!
Hand width
(required)
(required)
Convex form for normal hands,
flat form for short or strong hands.

As "normal" we call hands where the hand has the same width than the length of the middle finger.
E.g. a 95mm wide hand with a 90mm long middle finger, we would call "short"!
Hand length
(required)
0° lateral turning for a normal hand and head position so that the barrel axis points straight into the arm, 
7° lateral turning for a cross-dominant target eye, short hands (better reachability of the trigger) or an inward pulling front sight (to the left for right-handers).
(required)
Normal volume for normal hands,
thick volume (+5mm) for long hands.

As "long" we call hands where the middle finger is longer than the widht of the hand.
E.g. a 95mm wide hand with a 100mm long middle finger, we would call "long"!
Hand length
(required)
(required)
Walnut is the classic wood for grips and stocks. Due to the natural material, there may be deviations in brightness and texture.

For walnut deluxe only selected woods with a more beautiful grain are used.

Our laminated wood consists of colored veneers that are glued to the appropriate thickness. Even after corrections to the grip, the color is always retained.

> More infos
Here you can enter comments about the order:
If you are unsure about the selection of the grip parameters, you are welcome to upload a hand outline sketch with the order:
  • Please place your shooting hand on a sheet of paper, as shown on this sketch.
  • Draw with a thin ballpoint pen around the hand contour.
  • Make two reference lines, each 10cm long, horizontal and vertical on the sheet. The start and end points must be clearly visible!
  • Scan the sketch or photograph it vertically from above. The sides of the sheet must be parallel in the photo!
Handskizze > More infos
Drag & drop files (JPG, GIF, PNG...) here (Max. 1 file(s), max. 10 MB per file)
Share your configuration
Product number: GSP
**Final prices may differ, due to possible recalculations in the shopping cart.
Skip product gallery

Accessories

Walther GSP fixing part
Walther GSP fixing part

for grip mounting from below (more stable). Needed if you want to attach your GSP grip with a screw from below, instead of the two lateral screws. Conditions:- corresponding hole below in the frame- lower frame thickness is 16mmAttention: Check the screw length for your grip (there are different variants). A screw that is too long can damage the frame!

€22.29
Details
This website uses cookies to ensure the best experience possible. More information...